Allae Tweeter broken

[Paiste2002]

Hi all. I just discovered that one of my tweeters died silently. A multimeter shows infinte resitance when measuring the broken one (the other one shows zero resistance).

Removing the front plate by loosening the four wood screws is easy (no hylomar or glue). And lucky me that I have bought two replacement tweeters when these were discontinued.

What I’d like to know is what the torque setting will be when refitting the new tweeter to the suspension plate. For the SL2 Richard mentioned 0.8Nm, but does anybody know if this also applies to Allaes?

I feel I should replace both tweeters while at it. Any objections?

Thanks much and love and peace from Germany to you all.

[Skeptikal]

Found some references including this link to a post on here.

Naim Allae requirements

Regarding set up and tightening torques. I recieved an email reply from technical support with the following settings; ​The bass driver is 3.6nM. The tweeter plat is 0.8nM The 3 small woodsrews that secure the leaf spring to the cabinet 0.8nM The larger screws (2) at each end of the leaf spring into the base frame 3.6nM Following a browse online I haven’t found a torque wrench with a setting as low as 0.8nM

Hope this helps.
Oh and yes I’d replace the pair for balance whenever possible.

[Paiste2002]

You’re my man! Thank you so much!

[Skeptikal]

@Paiste2002

You’re my man! Thank you so much!

Most welcome and glad to help.