ND555 Automation port

Apologies, if this is a silly question but It’s not easy to check behind my Fraim as to which port I need to connect a 3mm cable to set up system automation.

I just had a look at the online manual but it wasn’t clear to me.
Also I presume the Rc5 port on the 552 is RCA? So I would need 3.5mm to RCA Mono cable

Yep. A 3.5mm mono jack to RCA cable is what you need. Connect it to the IR Out socket on the ND555

Thanks James, couldn’t see it but that makes sense. I’ll get a touch!

1 Like

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.