Supernait3 - 2 sets of speakers

Hi-Fi Corner
1

I want to connect my SN3 to 2 sets of speakers, each in a different room (speaker cables go through hole in the wall). If I add a NAP250 via the Bi-Amp connection, will the main speakers directly connected to the SN3 and the new speakers through the NAP250 play simultaneously? Or does bi-amping switch the main speakers off?

2

That will work. Though you wonā€™t be able to listen to the 250 without the sn3 also running. If you just want to play the sn3, you can switch the 250 off.

1 Like
3

Thanks! Not sure, if this relatively expensive solution makes sense, though :slight_smile:

4

I think you might need a better definition of what you are trying to solveā€¦ :wink:

5

I guess basically multi-rooming vinyl with two sets of speakers in two different roomsā€¦

1 Like
6

Your best bet for a simple way to add another ā€œzoneā€ here is to use another integrated amp and then feed it from the buffered ā€˜tapeā€™ out of the Supernait. That also means you have local volume control for the second zone - which is important, especially if the sensitivities of the speaker differ.

5 Likes
7

Agree to the second integrated amp, makes sense, but which output is the ā€žTapeā€œ out at the SN3? Sorry for my ignoranceā€¦

8

HDD in/out. Youā€™ll need a suitable low capacitance interconnect wired to take signal from the REC out pins of the DIN. Hopefully your dealer can make up something suitable here as itā€™s not exactly an off the shelf itemā€¦

2 Likes