Which cable and where?

[damn2k]

and this is the back

[anon4489532]

Did you connect a Snaic 5 to the end socket on the 32, the one with the little round cover? That’s where it should go.

This is the unofficial snaic 5 from flashback, isn’t it? Maybe it’s not wired properly. You could take it apart and have a look.

[Richard.Dane]

The bottom picture explains it to you - socket 3 to pre-amp (single rail supply - see the +ve). Socket 4 is for pre-amps that can take a Hicap (dual rail supply - see 2 x +ve).

So why socket 2 should be successfully powering your preamp with the SNAIC4, I just do not know! Are you sure you don’t mean you’re powering via socket 3?

[damn2k]

I have made other attempts but the only way to work is with the snaic4 cable.
I think I will run the service soon.

[Richard.Dane]

SNAIC4 via socket 2 or socket 3??

[damn2k]

in this way