Burndy concern

Replugged all my parts back in and shook the Burndy a bit to destress the wires

When all switched on the NDX2 came up with error 310 (or similar number)
Wobbled the Burndy at the psu end, turned back on and all was ok

Do I have a broken wire in the Burndy?

Probably not a broken wire, but just possibly a slightly dirty connection.

I suggest you turn off the power on the power supply the Burndy is connected to and then disconnect the Burndy and reconnect it fully half a dozen times at both ends. Now when you turn the power on it should be fine. If reasonably vigorous waggling of the Burndy causes any sort of problem, then you do have an issue that probably needs further investigation.

Best

David

Thanks David
Appreciate your help

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.