Just to be sure I am asking the question here.
Which connection should be the hot side when it is plugged in Naim equipment.
Or does it differs?
I thought left top one.
L = Hot. Since you are in NL you have a wall connector you can put two ways into it. You can get a phase pen to localise this if you don’t have it.
1 Like
Thanks! and that is most common for Naim equipment of for mostly al equipment?
Yes that’s the normal way. But the connector type you show a photo of is not C19. It’s a C13. But the hot pin is positioned the same on them
Here’s a C19 IEC.
1 Like
Thanks for your quick reaction. I also changed the title accordingly.
1 Like
Maybe this will be helpful
1 Like
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.