Hi how can i change a large spade to fit my naim nap250dr loudspeaker output exept cutting them please ,
Without cutting it, I doubt you can. I assume you need the banana plugs fitted? Naim actually make a special plug but would recommend these are fitted by a dealer as the soldering is tricky and not for the inexperienced!
Yes , i bought a pair of used MIT TERMINATOR 4 bi-wire 4.5m pair of loudspeakers cables 4 bannana plugs to two spades outputs each cable , ive just found something on amazon CNCESS CES -187 that might be ok THEY LOOK PERFECT , i have a naim uniti2 as a cd preamp & naim nap250dr poweramp , ive just bought a
BK electronics XLS300-DF subwoofer used , ill wire into my martin logan aerius i loudspeakers it should be quite a nice little set up ,then ill upgrade the uniti2 to possibly a used naim nac n 272 when the funds are availble
Naim plugs are the best fit and are best fitted by your dealer.
If I were you I’d think about some stock Naim NAC5 speaker cable with Naim banana plugs. Do not underestimate just how good these cables are with Naim kit. I still use them with my big Naim system as I’ve found little that can better them.
100%, the MIT TERMINATOR 4 bi-wire is not good for a 250. Bi-wiring halves the all important required Naim induction load. Plus that box ‘thing’ tunes out most all the inductance thats left anyway
Oowps my bad , ah well thats life , thanks for the reply
Google “Spade to Banana” connector. Bazillions of them out there.
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.