Hi all. I have a NAC 62 with a dicky function selector. Problem ! it can cut out on a channel at any time and make a t very scratchy noise. It is fix by changing the selector a few times.
1 Is it able to be repaired ?
2 can I buy the part some where?
The NAC62 uses an ALPS remote selector - that keeps the selector switch close to the input sockets. These can wear and go noisy with time. You could try a squirt of switch cleaner on it and run it back and forth a bit in the hope that it cleans it up. However, if that doesn’t work the only solution is replacement and I don’t know whether Naim have any more of these (you’d need to check with Naim Support). Note that Naim do not sell parts to anyone but approved Naim servicers.
I’ m afraid i’m m having the same issue with my recently acquired Nac 62. It’ s fine with line inputs but with phono, especially with the Sondek connected, there’ s a very low output level, with right channel almost dead, cycling with inputs seem to sort It partially, It seems there is also a certain amount of distortion. I’ ll investigate with my dealer when collection the Snaps next week